RELAY (w/ Headlight Cleaner System) REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01JAHH

      Remove the 3 clips.

    2. Disengage the 2 claws and remove the radiator support opening cover.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. A01JD5JE01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A01JAG6

      Using a screwdriver, turn the pins 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A01JA6C

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01JC94

      Remove the 2 bolts and 4 screws.

    5. Using a clip remover, remove the 7 clips.

    6. A01JCXU

      Using a clip remover, remove the 2 clips. (w/ Front Spoiler)

    7. Remove the 2 screws. (w/ Front Spoiler)

    8. Disengage the 2 guides and remove the front spoiler cover. (w/ Front Spoiler)

    9. A01JC21

      Disengage the 3 claws and remove the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    10. Disconnect each connector.

    11. Disconnect the headlight cleaner hose and drain the washer fluid. (w/ Headlight Cleaner System)

      Tech Tips

      Use a container to collect the washer fluid.

    12. A01J8EC

      Remove the front bumper assembly as shown in the illustration.

  3. REMOVE INLET AIR CLEANER ASSEMBLY


    1. A01JBG6

      Separate the water by-pass hose from the inlet air cleaner assembly.

    2. Separate the wire harness clamp from the inlet air cleaner assembly.

    3. Remove the 3 bolts and inlet air cleaner assembly.

  4. REMOVE HEADLIGHT CLEANER CONTROL RELAY


    1. A01JAQ9

      Disengage the clip and separate the washer jar cap of the washer jar assembly.

    2. A01JAWS

      Disconnect the 2 connectors.

    3. Disengage the clamp.

    4. Remove the 2 bolts.

    5. A01JAJX

      Disengage the hose clamp.

    6. Disconnect the 2 washer hoses, and drain the washer fluid.

      Tech Tips

      Use a container to collect the washer fluid.

    7. A01JA4R

      Disconnect the 2 connectors.

    8. Disengage the clamp.

    9. Remove the bolt and the washer jar assembly.

    10. A01JCVL

      Disengage the claw and remove the headlight cleaner control relay as shown in the illustration.