WASHER NOZZLE (for Rear Side) INSTALLATION


  1. INSTALL REAR WASHER NOZZLE


    1. A01JCS4

      Connect the washer hose.

    2. A01JD9K

      Engage the 2 claws to install the rear washer nozzle.

  2. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A01J9Q5

      Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.

  3. INSPECT REAR WASHER NOZZLE


    1. With the engine running, check that the center stream of washer fluid sprays on the windshield within the hatched area shown in the illustration.

      Standard
      Washer fluid hits the windshield in the area shown in the illustration.
      A01JAFUE01
      Standard Clearance
      Area Measurement
      A 48.7 mm (1.92 in.)

      Tech Tips

      If the result is not as specified, replace the malfunctioning rear washer nozzle.

  4. ADJUST REAR WASHER NOZZLE


    1. A01JATH

      Using a screwdriver, adjust the direction of the rear washer nozzle.

      Note

      Do not use a safety pin or other pointed tools. Doing so may damage the inside of the washer nozzle.

      Tech Tips

      Use a thin-bladed screwdriver with an approximately 1 mm (0.0394 in.) thick tip.