RAIN SENSOR ON-VEHICLE INSPECTION


  1. INSPECT RAIN SENSOR


    1. A01JA41E07
      Text in Illustration
      *1

      Front view of wire harness connector

      (to Rain Sensor)

      Disconnect the U11 rain sensor connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      U11-1 (ES) - Body ground Always Below 1 Ω

      If the result is not as specified, repair or replace the harness or connector.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      U11-4 (SIG) - Body ground Power switch on (IG) 11 to 14 V

      If the result is not as specified, repair or replace the harness or connector.

    4. A01J9Q9E11
      Text in Illustration
      *1

      Component with harness connected

      (Rain Sensor)

      Reconnect the rain sensor connector.

    5. Connect an oscilloscope to the rain sensor connector.

    6. Check for pulses.

      OK
      Tester Connection Condition Specified Condition
      U11-3 (AUTO) - U11-1 (ES) Power switch on (IG) Pulse generation

      If the result is not as specified, replace the rain sensor.