REAR WIPER MOTOR INSTALLATION


  1. INSTALL REAR WIPER MOTOR ASSEMBLY


    1. A01JA0J

      Install the rear wiper motor assembly with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Connect the connector.

  2. INSTALL BACK DOOR TRIM BOARD


    1. A01JD91

      Engage the 5 clips and 2 guides to install the back door trim board.

  3. INSTALL BACK DOOR TRIM BOARD ASSEMBLY


    1. A01J8I5

      Engage the 11 clips and 2 claws to install the back door panel trim assembly.

  4. INSTALL BACK DOOR SIDE GARNISH LH


    1. A01JD5B

      Engage the 3 clips and 2 claws to install the back door side garnish LH.

  5. INSTALL BACK DOOR SIDE GARNISH RH


    1. A01JBBG

      Engage the 3 clips and 2 claws to install the back door side garnish RH.

  6. INSTALL UPPER BACK DOOR TRIM PANEL ASSEMBLY


    1. A01J9Q5

      Engage the 4 clips and 4 claws to install the upper back door trim panel assembly.

  7. INSTALL REAR WIPER MOTOR GROMMET


    1. A01JBXKE05
      Text in Illustration
      *1 MP grease

      Apply MP grease to the entire surface of the rear wiper motor grommet lip.

      Tech Tips

      Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.

    2. A01JAYSE01

      Install the rear wiper motor grommet.

      Tech Tips

      Install the grommet with its alignment mark facing up.

      Text in Illustration
      *1 Alignment Mark

  8. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY


    1. Operate the wiper and stop the windshield wiper motor at the automatic stop position.

    2. When reusing the rear wiper arm and blade assembly:


      1. A01JCBUE03
        Text in Illustration
        *1 Wiper Arm Serration

        Clean the wiper arm serrations.

    3. When reusing the rear wiper motor assembly:


      1. A01J9S2E03
        Text in Illustration
        *1 Wire Brush
        *2 Wiper Pivot Serration

        Clean the wiper pivot serrations with a wire brush.

    4. A01J8XTE01
      Text in Illustration
      *1 Ceramic Dot

      Install the rear wiper arm and blade assembly with the nut to the position shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the wiper arm by hand while tightening the nut.

    5. Operate the rear wiper while spraying washer fluid onto the back door glass. Make sure that the rear wiper functions properly and the wiper does not come into contact with the vehicle body.

    6. w/ Steel Wiper Arm:


      1. Close the rear wiper arm head cap.

  9. INSTALL REAR WIPER ARM HEAD CAP (w/ Resin Wiper Arm)


    1. A01J8M3

      Engage the 2 claws to install the rear wiper arm head cap.

    2. A01J93E

      Engage the 2 claws to close the rear wiper arm head cap as shown in the illustration.