OUTER REAR VIEW MIRROR REASSEMBLY


  1. INSTALL OUTER MIRROR RETRACTOR


    1. A01J99B

      Pass a new wire harness through the motor and frame sub-assembly from the top as shown in the illustration.

    2. A01JDA5

      Connect the connector to the frame sub-assembly.

    3. A01JC6K

      Engage the guide as shown in the illustration to temporary install the frame sub-assembly to the housing.

    4. A01JA1X

      Install the frame sub-assembly with the 2 screws.

    5. A01JAXW

      Connect the 2 connectors.

    6. Engage the clamp.

    7. A01J9IN

      Install the mirror actuator with the 3 screws.

      Note

      When installing the mirror actuator, check that the wire harness is not caught.

    8. A01JA8A

      Using a T25 "TORX" socket wrench, install the base with 3 new screws.

      Torque:
      3.8 N*m  { 39 kgf*cm, 34 in.*lbf }

      Note

      When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.

    9. A01J8HGE01
      Text in Illustration
      *a Marking
      *b Position of the Clamp

      Set the marking of the wire harness to the position shown in the illustration to engage it.

    10. A01J9ER

      Engage the guide and 6 claws and install the new lower cover.

    11. A01JC5Q

      Pass the wire harness through the new gasket to install it.

    12. A01JBO2E04
      Text in Illustration
      *1 Twisted wire harness

      Install each connector to the adapter as shown in the illustration.

    13. A01J9BPE01

      Wrap new vinyl tape as shown in the illustration.

      Area Measurement
      A 40 mm (1.57 in.)

  2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY


    1. A01JCF6

      Install the side turn signal light assembly with the 3 screws.

    2. Connect the connector.