OUTER REAR VIEW MIRROR INSPECTION


  1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH


    1. Inspect outer mirror motor operation.


      1. A01J91WE01
        Text in Illustration
        *1

        Component without harness connected

        (Outer Rear View Mirror Assembly LH)

        Apply battery voltage and check the operation of the mirror face, as shown in the table and illustration.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 7 (M+)

        Battery negative (-) → Terminal 3 (MV)

        		 Turns downward

        Battery positive (+) → Terminal 3 (MV)

        Battery negative (-) → Terminal 7 (M+)

        		 Turns upward

        Battery positive (+) → Terminal 6 (MH)

        Battery negative (-) → Terminal 7 (MV+

        		 Turns left

        Battery positive (+) → Terminal 7 (M+)

        Battery negative (-) → Terminal 6 (MH)

        		 Turns right

        If the result is not as specified, replace the outer rear view mirror assembly LH.

    2. Check the mirror heater (w/ Mirror heater).


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Terminal 1 (HL-) - Terminal 2 (HL+) 25°C (77°F) 7.6 to 11.4 Ω

        If the result is not as specified, replace the outer rear view mirror assembly.

  2. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY RH


    1. Inspect outer mirror motor operation.


      1. A01JBD4E01
        Text in Illustration
        *1

        Component without harness connected

        (Outer Rear View Mirror Assembly RH)

        Apply battery voltage and check the operation of the mirror face, as shown in the table and illustration.

        OK
        Measurement Condition Specified Condition

        Battery positive (+) → Terminal 7 (M+)

        Battery negative (-) → Terminal 3 (MV)

        		 Turns downward

        Battery positive (+) → Terminal 3 (MV)

        Battery negative (-) → Terminal 7 (M+)

        		 Turns upward

        Battery positive (+) → Terminal 6 (MH)

        Battery negative (-) → Terminal 7 (M+)

        		 Turns left

        Battery positive (+) → Terminal 7 (M+)

        Battery negative (-) → Terminal 6 (MH)

        		 Turns right

        If the result is not as specified, replace the outer rear view mirror assembly RH.

    2. Check the mirror heater (w/ Mirror heater).


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        Terminal 1 (HR-) - Terminal 2 (HR+) 25°C (77°F) 7.6 to 11.4 Ω

        If the result is not as specified, replace the outer rear view mirror assembly.