HOOD LOCK CONTROL CABLE ASSEMBLY INSTALLATION


  1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. Pass the hood lock control cable assembly into the engine compartment.

      A01JALXE01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Grommet
      *3 Hood Cable Grommet - -

    2. Pass the cable through the upper radiator support.

    3. Engage each clamp shown in the illustration.

    4. A01JA8Z

      Connect the hood lock control cable assembly.

  2. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. Pass the hood lock control cable assembly into the engine compartment.

      A01JCJUE01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Grommet
      *3 Hood Cable Grommet - -

    2. Pass the cable through the upper radiator support.

    3. Engage each clamp shown in the illustration.

    4. A01JASG

      Connect the hood lock control cable assembly.

  3. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01JAT6

      Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

  4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    1. Connect each connector.

    2. Engage the clamp.

    3. A01J9TK

      Engage the 2 guides and claw to connect the hood lock control cable.

    4. A01J9Q6

      Engage the 6 claws and clip.

    5. A01JA5Y

      Install the lower instrument panel finish panel assembly with the screw <C>.

  5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY


    1. A01J99M

      Engage the 2 clips.

    2. Install the cowl side trim board LH with the clip.

  6. INSTALL FRONT DOOR SCUFF PLATE


    1. A01JB0N

      Engage the 10 claws to install the front door scuff plate LH.

  7. INSTALL FRONT FENDER LINER LH (for LHD)

    Tech Tips

    Use the same procedure for the RH side and LH side.

  8. INSTALL FRONT FENDER LINER RH (for RHD)


    1. A01JBM4

      Install a new grommet and the 4 screws.

    2. Install the 10 clips.

    3. A01JCG3E01
      Text in Illustration
      *1 Correct
      *2 Incorrect

      Install the pin hold clip as shown in the illustration.

      Note

      Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

  9. INSTALL FRONT WHEEL LH (for LHD)

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  10. INSTALL FRONT WHEEL RH (for RHD)

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }