HOOD LOCK CONTROL CABLE ASSEMBLY REMOVAL


  1. REMOVE FRONT WHEEL LH (for LHD)

  2. REMOVE FRONT WHEEL RH (for RHD)

  3. REMOVE FRONT FENDER LINER LH (for LHD)

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  4. REMOVE FRONT FENDER LINER RH (for RHD)


    1. A01J8ZFE01

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

    2. A01JBM4

      Remove the 10 clips and 4 screws.

    3. Using a clip remover, remove the grommet and the front fender liner RH.

      Tech Tips

      The grommet needs to be replaced with new one because it will break when it is removed.

  5. REMOVE FRONT DOOR SCUFF PLATE


    1. A01JB0N

      Disengage the 10 claws and remove the front door scuff plate LH.

  6. REMOVE COWL SIDE TRIM SUB-ASSEMBLY


    1. A01J99M

      Remove the clip.

    2. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.

  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY


    1. A01J8VP

      Remove the screw <C>.

    2. A01J9JX

      Disengage the 6 claws and clip as shown in the illustration.

    3. A01J9TK

      Disengage the claw and 2 guides and disconnect the hood lock control cable.

    4. Disconnect each connector and clamp, and remove the lower instrument panel finish panel assembly.

  8. REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    1. A01JAT6

      Disconnect the hood lock control cable assembly from the hood lock control lever sub-assembly.

  9. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)


    1. A01JA8Z

      Disconnect the hood lock control cable assembly.

    2. Using a screwdriver, disengage each clamp shown in the illustration.

      A01JALXE01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Grommet
      *3 Hood Cable Grommet - -

      Tech Tips

      Tape the screwdriver tip before use.

    3. Pull the hood lock control cable assembly from the engine compartment and remove it.

  10. REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)


    1. A01JASG

      Disconnect the hood lock control cable assembly.

    2. Using a screwdriver, disengage each clamp shown in the illustration.

      A01JCJUE01
      Text in Illustration
      *1 Hood Lock Control Cable *2 Grommet
      *3 Hood Cable Grommet - -

      Tech Tips

      Tape the screwdriver tip before use.

    3. Pull the hood lock control cable assembly from the engine compartment and remove it.