SLIDING ROOF SWITCH ASSEMBLY INSPECTION


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. A01JBP4E02
      Text in Illustration
      *1

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      U13-2 (CLS) - U13-9 (GND1) CLOSE switch is pressed Below 1 Ω
      U13-2 (CLS) - U13-9 (GND1) CLOSE switch is not pressed 10 kΩ or higher
      U13-16 (OPN) - U13-9 (GND1) OPEN switch is pressed Below 1 Ω
      U13-16 (OPN) - U13-9 (GND1) OPEN switch is not pressed 10 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).