FRONT SEAT OUTER BELT ASSEMBLY REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE FRONT DOOR SCUFF PLATE


    1. A01JB0N

      Disengage the 10 claws and remove the front door scuff plate LH.

  7. REMOVE REAR DOOR SCUFF PLATE


    1. A01JA7L

      Disengage the 7 claws and remove the rear door scuff plate LH.

  8. REMOVE LAP BELT OUTER ANCHOR COVER


    1. A01JB4X

      Disengage the 3 claws and remove the lap belt outer anchor cover.

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A01J9GA

      Remove the bolt and disconnect the floor end of the front seat outer belt assembly.

  10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    1. A01JBR0

      Remove the front door opening trim weatherstrip LH.

  11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH


    1. A01JAU4

      Remove the rear door opening trim weatherstrip LH.

  12. REMOVE CENTER PILLAR LOWER GARNISH


    1. A01JAI1

      Disengage the 2 claws and 2 clips, and remove the center pillar lower garnish LH.

  13. REMOVE CENTER PILLAR GARNISH


    1. A01JAOI

      Remove the screw.

    2. Using a clip remover, disengage the clip.

    3. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar garnish LH and remove the center pillar garnish LH.

  14. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A01JD1D

      Remove the nut and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A01JAIF

      Using a screwdriver, pull out the locking button in the direction shown by the arrow in the illustration to release the lock, and disconnect the pretensioner connector as shown in the illustration.

      Tech Tips

      Tape the screwdriver tip before use.

    3. Disconnect each connector.

    4. A01JBF6

      Remove the 2 bolts and front seat outer belt assembly.

  15. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A01J955

      Remove the 2 bolts.

    2. Disengage the guide and remove the front shoulder belt anchor adjuster assembly.