OCCUPANT DETECTION SENSOR INSTALLATION


  1. INSTALL OCCUPANT DETECTION SENSOR


    1. A01JD57

      Using hog ring pliers, install 11 new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

    2. A01JB9M

      Using hog ring pliers, install the separate type front seat cushion cover to the occupant detection sensor with 2 new hog rings.

      Note


      • Be careful not to damage the cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

  2. INSTALL FRONT SEAT CUSHION COVER WITH PAD

    Tech Tips

    Use the same procedure described for the LH side Click here.

  3. INSTALL FRONT SEAT CUSHION INNER SHIELD

    Tech Tips

    Use the same procedure described for the LH side Click here.

  4. INSTALL FRONT SEAT INNER BELT ASSEMBLY

    Tech Tips

    Use the same procedure described for the LH side Click here.

  5. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY

    Tech Tips

    Use the same procedure described for the LH side Click here.

  6. INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

    Tech Tips

    Use the same procedure described for the LH side Click here.

  7. INSTALL RECLINING ADJUSTER RELEASE HANDLE

    Tech Tips

    Use the same procedure described for the LH side Click here.

  8. INSTALL FRONT SEAT ASSEMBLY

    Tech Tips

    Use the same procedure described for the LH side Click here.

  9. INSTALL INNER SEAT TRACK COVER

    Tech Tips

    Use the same procedure described for the LH side Click here.

  10. INSTALL OUTER SEAT TRACK COVER

    Tech Tips

    Use the same procedure described for the LH side Click here.

  11. INSTALL FRONT SEAT HEADREST ASSEMBLY

    Tech Tips

    Use the same procedure described for the LH side Click here.

  12. INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

    Tech Tips

    Use the same procedure described for the LH side Click here.

  13. INSTALL REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Engage the 2 guides to install the rear No. 3 floor board.

  14. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  15. INSTALL REAR NO. 2 FLOOR BOARD


    1. A01JCWRE01

      Engage the 3 guides <A>.

    2. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.

  16. INSPECT FRONT SEAT ASSEMBLY


    1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.

      If the seat adjusters do not lock simultaneously, loosen the seat mounting bolts to adjust the adjuster position.

    2. w/ Seat Heater Seat System:

      Check the seat heater operation.


      1. Turn the power switch on (IG).

      2. Push the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  17. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.