LUMBAR SWITCH (for Manual Seat) INSTALLATION


  1. INSTALL LUMBAR SWITCH


    1. A01J9PV

      Install the lumbar switch with the 2 screws.

  2. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY


    1. A01JAOR

      Disengage the 5 clamps.

    2. Connect the connector.

    3. A01JCR1

      Engage the clip and 2 claws.

    4. Install the front seat cushion shield assembly with the screw.

  3. INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)


    1. A01J9YL

      Install the vertical adjusting handle with the screw.

  4. INSTALL RECLINING ADJUSTER RELEASE HANDLE


    1. A01JCPN

      Engage the claw and install the reclining adjuster release handle.

  5. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect the connectors under the seat.

    3. Temporarily install the front seat assembly with the 4 bolts.

    4. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    5. A01JATSE01

      Tighten the 2 bolts on the front side of the seat.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

    6. Lift up the seat track adjusting handle and move the seat to the foremost position.

    7. A01J916E01

      Tighten the 2 bolts on the rear side of the seat.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Tech Tips

      Tighten the bolts in the order indicated in the illustration.

  6. INSTALL INNER SEAT TRACK COVER


    1. A01JBVL

      Engage the claw and guide and install the inner seat track cover.

  7. INSTALL OUTER SEAT TRACK COVER


    1. A01J9SP

      Engage the 2 claws and install the outer seat track cover.

  8. INSTALL FRONT SEAT HEADREST ASSEMBLY


    1. A01J9I8

      Install the front seat headrest assembly as shown in the illustration.

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. INSTALL REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Engage the 2 guides to install the rear No. 3 floor board.

  11. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  12. INSTALL REAR NO. 2 FLOOR BOARD


    1. A01JCWRE01

      Engage the 3 guides <A>.

    2. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.

  13. INSPECT FRONT SEAT ASSEMBLY


    1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.

      If the seat adjusters do not lock simultaneously, loosen the seat mounting bolts to adjust the adjuster position.

    2. w/ Seat Heater Seat System:

      Check the seat heater operation.


      1. Turn the power switch on (IG).

      2. Push the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  14. INSPECT SRS WARNING LIGHT

    Tech Tips

    Inspect the SRS warning light Click here.