AIRBAG CUT-OFF SWITCH INSTALLATION


  1. INSTALL AIRBAG CUT-OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A01JC0A

      Engage the 2 claws to install the airbag cut-off switch cylinder sub-assembly.

  2. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


    1. A01JCP4

      Engage the guide as shown in the illustration.

    2. A01JBC7

      Engage the guide as shown in the illustration.

    3. A01J98N

      Engage the 4 claws to install the instrument panel finish panel end RH.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. INSTALL REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Engage the 2 guides to install the rear No. 3 floor board.

  5. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  6. INSTALL REAR NO. 2 FLOOR BOARD


    1. A01JCWRE01

      Engage the 3 guides <A>.

    2. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.

  7. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.

  8. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.