AIRBAG CUT-OFF SWITCH REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    w/ Navigation System for HDD:

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE INSTRUMENT PANEL FINISH PANEL END RH


    1. A01JA4B

      Pull the instrument panel finish panel end RH in the direction indicated by the arrow to disengage the 4 claws.

    2. A01JA0U

      Disengage the guide as shown in the illustration.

    3. A01J8XA

      w/o Airbag Cut Off Switch:


      1. Disengage the guide and remove the instrument panel finish panel end RH as shown in the illustration.

    4. w/ Airbag Cut Off Switch:


      1. Disengage the guide.

      2. Disconnect the connector and remove the instrument panel finish panel end RH as shown in the illustration.

  7. REMOVE AIRBAG CUT-OFF SWITCH CYLINDER SUB-ASSEMBLY


    1. A01JC0A

      Disengage the 2 claws to remove the airbag cut-off switch cylinder sub-assembly.