CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly with the 5 hooks.

      A01J9PP

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    4. Install the curtain shield airbag assembly to the body panel with 4 new clips and 4 new spacers.

      A01JB9X

      1. A01JCNVE04
        Text in Illustration
        *1 Pin
        *2 Clip
        *3 Airbag
        *4 Body
        *5 Spacer

        Install 4 new pins as shown in the illustration.

        Note

        Make sure that the pins of the clips are pushed in firmly.

    5. Install the 5 bolts.

      A01J8JG
      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
    6. A01JCSQ

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    7. Push in the lock to install the airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure from Install Roof Headlining Assembly Click here.

  3. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.

  4. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.