CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

  2. REMOVE ROOF HEADLINING ASSEMBLY

    Tech Tips

    Refer to the procedure up to Remove Roof Headlining Assembly Click here.

  3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY

    CAUTION:

    When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01J9IQE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with the tip wrapped with protective tape, release the airbag connector lock and disconnect the curtain shield airbag connector.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    4. Remove the 5 bolts.

      A01J8JG

    5. Remove the 4 clips.

      A01JB9X

      1. A01JDAJE05
        Text in Illustration
        *1 Pin
        *2 Clip
        *3 Airbag
        *4 Body

        Using a clip remover, remove the 4 pins.

      2. A01J9XME09
        Text in Illustration
        *1 Clip
        *2 Airbag
        *3 Body
        *4 Spacer

        Using a screwdriver with the tip wrapped with protective tape, separate the 4 clips and curtain shield airbag assembly from the body as shown in the illustration.

    6. Disengage the 5 hooks to remove the curtain shield airbag assembly.

      A01J9PP

    7. Remove the 4 clips and 4 spacers from the curtain shield airbag assembly.