FRONT PASSENGER AIRBAG ASSEMBLY INSTALLATION


  1. INSTALL NO. 3 INSTRUMENT PANEL WIRE


    1. A01J8VB

      Connect the airbag connector to the front passenger airbag assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    2. Push in the lock to install the airbag connector.

    3. Connect the No. 3 instrument panel wire to the front passenger airbag assembly clamp.

    4. Engage the clamp to install the No. 3 instrument panel wire to the front passenger airbag assembly.

  2. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY


    1. A01JC0E

      Engage the 3 hooks.

    2. A01JC2M

      Push the front passenger airbag assembly to engage the 3 hooks.

    3. A01JBZE

      Install the 2 screws to install the front passenger airbag assembly.

    4. Install the 2 clamps to the front passenger airbag assembly.

  3. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY


    1. When using a new upper instrument panel sub-assembly:


      1. Immediately before installing the upper instrument panel assembly, twist and cut off the portions shown in the illustration.

        A01JAGO

    2. Engage the 5 claws as shown in the illustration.

    3. Engage the 2 claws and 4 clips, and install the upper instrument panel assembly as shown in the illustration.

      A01JBHIE01

    4. Install the 2 bolts <B>.

    5. Install the 2 passenger airbag bolts <A>.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }
      A01J97YE01
      Text in Illustration
      *1 Passenger Airbag Bolt <A> *2 Bolt <B>

    6. Engage the 2 clamps.

    7. Connect each connector.

      A01JATT

  4. CONNECT NO. 3 INSTRUMENT PANEL WIRE


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01JBAK

      Connect the connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  5. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Tech Tips

    Refer to the procedure from Install Center Instrument Cluster Finish Panel Garnish Click here.

  6. PERFORM DIAGNOSTIC SYSTEM CHECK


    1. Perform a diagnostic system check Click here.