SPIRAL CABLE INSTALLATION


  1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable with the battery connected and the power switch on (IG).

    • Do not rotate the spiral cable with the battery connected and the power switch on (IG).

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

    • Do not remove the steering sensor from the spiral cable.


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

    3. Check that the front wheels are facing straight ahead.

    4. Set the turn signal switch to the neutral position.

      Note

      If it is not in the neutral position, the turn signal switch pin may snap.

    5. A01JB3T

      Install the spiral cable with sensor sub-assembly with the 3 claws.

      Note

      When replacing the spiral cable with sensor sub-assembly with a new one, remove the lock pin before installing the steering wheel assembly.

    6. Connect the connectors to the spiral cable with sensor sub-assembly.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

  2. INSTALL UPPER STEERING COLUMN COVER


    1. A01JBS6

      Engage the 2 claws and 2 pins to install the upper steering column cover.

  3. INSTALL LOWER STEERING COLUMN COVER

    Note

    If the lower steering column cover is installed in the incorrect order, it will not be possible to assemble the lower steering column cover.


    1. A01JA4M

      Engage the 2 claws to install the lower steering column cover.

    2. A01JCB7

      Engage the 4 claws.

    3. A01J9OE

      Engage the 2 claws.

      Tech Tips

      Press the area around the claws to engage them.

  4. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

  5. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01JAID

      Rotate the spiral cable counterclockwise slowly by hand until it stops.

      Note

      Do not turn the spiral cable using the airbag wire harness.

    4. A01J9WYE01
      Text in Illustration
      *1 Alignment Mark

      Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

      Note

      Do not turn the spiral cable using the airbag wire harness.

      Tech Tips

      The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.

  6. INSTALL STEERING WHEEL ASSEMBLY

    Tech Tips

    Refer to the procedure from Install Steering Wheel Assembly Click here.