METER / GAUGE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


    1. Warm up the engine.

    2. Turn the power switch off.

    3. Connect the intelligent tester to the DLC3.

    4. Turn the power switch on (IG).

    5. Turn the intelligent tester on.

    6. Enter the following menus:


      1. for Combination Meter: Body / Combination Meter / Data List.

      2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List.

      3. for Engine: Powertrain / Engine / Data List.

    7. Check the values by referring to the table below.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Tail Cancel SW Tail cancel switch/OFF or ON OFF: Tail cancel switch off -
      ON: Tail cancel switch on
      P-Seatbelt Buckle SW Front passenger side seat belt buckle switch/OFF or ON OFF: Front passenger side seat belt unfastened -
      ON: Front passenger side seat belt fastened
      Vehicle Speed Meter Vehicle speed/Min.: 0 km/h (0 mph), Max.: 199 km/h (124 mph) Almost the same as actual vehicle speed (Speedometer tester) -
      Coolant Temperature Engine coolant temperature/-40 to 127.5°C (-40 to 261.5°F) After warming up: 80 to 100°C (176 to 212°F) -
      Head Up Display Switch (Up) Headup display position up switch/OFF or ON OFF: Headup display position up switch not pressed -
      ON: Headup display position up switch pressed
      Head Up Display Switch (Down) Headup display position down switch/OFF or ON OFF: Headup display position down switch not pressed -
      ON: Headup display position down switch pressed
      Head Up Display Switch (Main) Headup display main switch/OFF or ON OFF: Headup display main switch not pressed -
      ON: Headup display main switch pressed
      Timer Switch M on Combination Meter Minute adjust switch/OFF or ON OFF: Minute adjust switch not pressed -
      ON: Minute adjust switch pressed
      Timer Switch H on Combination Meter Hour adjust switch/OFF or ON OFF: Hour adjust switch not pressed -
      ON: Hour adjust switch pressed
      Timer Switch 00 on Combination Meter Second adjust switch/OFF or ON OFF: Second adjust switch not pressed -
      ON: Second adjust switch pressed
      Fuel Input Fuel input signal/Min.: 0, Max.: 127.5 10th segment comes on: 39.6 to 45.0 Unit: Liter
      9th segment comes on: 35.7 to 39.6
      8th segment comes on: 31.8 to 35.7
      7th segment comes on: 27.9 to 31.8
      6th segment comes on: 24.0 to 27.9
      5th segment comes on: 20.1 to 24.0
      4th segment comes on: 16.2 to 20.1
      3rd segment comes on: 12.3 to 16.2
      2nd segment comes on: 8.4 to 12.3
      1st segment comes on: 6.1 to 8.4
      Check Engine SW Check power switch/OFF or ON OFF: Check power switch off -
      ON: Check power switch on
      Light Control Up SW Light control rheostat up switch/OFF or ON OFF: Light control rheostat up switch not pressed -
      ON: Light control rheostat up switch pressed
      Light Control Down SW Light control rheostat down switch/OFF or ON OFF: Light control rheostat down switch not pressed -
      ON: Light control rheostat down switch pressed
      Light Control Switch Display contrast adjust switch/OFF or ON OFF: Display contrast adjust switch not pressed -
      ON: Display contrast adjust switch pressed
      Multi Display Select Switch DISP switch in the multi-information switch (steering pad switch assembly)/OFF or ON OFF: DISP switch in the multi-information switch (steering pad switch assembly) not pressed -
      ON: DISP switch in the multi-information switch (steering pad switch assembly) pressed
      Drive Monitor Reset SW TRIP switch in the steering pad switch assembly/OFF or ON OFF: TRIP switch in the steering pad switch assembly not pressed -
      ON: TRIP switch in the steering pad switch assembly pressed more than 1 second
      +B Voltage Value Battery voltage/Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      TPMS Operation State*1 Condition of the tire pressure warning system/OFF, ON or Unknown OFF: Tire pressure warning system not operating -
      ON: Tire pressure warning system operating
      Unknown: Wire harness between combination meter assembly and tire pressure warning ECU and receiver open
      Oil Pressure Switch Oil pressure switch/OFF or ON OFF: Engine oil pressure low -
      ON: Engine oil pressure not low
      Key Remind Sound The customized setting of the key remind buzzer/Normal, Fast, Slow - The customized setting of the key reminder buzzer displayed
      Driver Side Seatbelt Warning Buzzer The condition of the driver side seat belt warning buzzer/OFF or ON OFF: The driver side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened The customized setting of the driver side seat belt warning buzzer is displayed
      ON: The driver side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the driver side seat belt unfastened
      P-Seatbelt Warning Buzzer The condition of the front passenger side seat belt warning buzzer/OFF or ON OFF: The front passenger side seat belt warning buzzer does not sound at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened The customized setting of the front passenger side seat belt warning buzzer is displayed
      ON: The front passenger side seat belt warning buzzer sounds at the vehicle speed of 20 km/h (12 mph) or more when the front passenger side seat belt unfastened
      Tail OFF Indicator The customized setting of the tail indicator light/OFF or ON OFF: When the light control switch TAIL or HEAD position, tail indicator light off The customized setting of the tail off indicator displayed
      ON: When the light control switch TAIL or HEAD position, tail indicator light on
      Reverse Buzzer The customized setting of the reverse buzzer/Continual or Single Continual: When the shift lever moves to R, buzzer sounds continuously The customized setting of the reverse buzzer displayed
      Single: When the shift lever moves to R, a single buzzer sounds
      Number of Trouble Code The number of the DTC which is currently output 0 -

      • *1: w/ Tire Pressure Warning System

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      FR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) Almost the same as actual vehicle speed (Speedometer tester) -
      FL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) Almost the same as actual vehicle speed (Speedometer tester) -
      RR Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) Almost the same as actual vehicle speed (Speedometer tester) -
      RL Wheel Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) Almost the same as actual vehicle speed (Speedometer tester) -
      Vehicle Speed Vehicle speed/Min.: 0 km/h (0 mph), Max.: 326 km/h (203 mph) Almost the same as actual vehicle speed (Speedometer tester) -
      Engine
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Coolant Temp Engine coolant temperature/Min.: -40°C (-40°F), Max.: 215°C (419°F) 80 to 100°C (176 to 212°F): After warming up

      • If -40°C (-40°F): sensor circuit open

      • If 140°C (284°F) or more: sensor circuit shorted

  2. ACTIVE TEST

    Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the intelligent tester to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Body / Combination Meter / Active Test.

    5. Check the operation by referring to the table below.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Speed Meter Operation Speedometer 0, 40, 80, 120 mph*1 -
      0, 40, 80, 120, 160, 200, 240 km/h*2
      Fuel Meter Operation Fuel receiver gauge EMPTY, 1/2, FULL -
      Fuel Consumption Meter Operation Fuel consumption meter OFF, MIN., 1/4, 1/2, 3/4, MAX. -
      A/T Indicator Operation 1 Shift indicator light (D, P, N. R, 4, 3, 2, L) D, P, N. R, 4, 3, 2, L -
      A/T Indicator Operation 2 Shift indicator light (S, 6, 5) OFF or ON -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Open door indicator light OFF or ON -
      Front Passenger Side Seat Belt Front passenger side seat belt warning light OFF or ON -
      Driver Side Seat Belt Driver side seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Coolant Hot Engine coolant hot warning light OFF or ON -
      Indicat. Lamp Beam High beam indicator light OFF or ON -
      Indicat. Lamp Tail Tail indicator light OFF or ON -
      Indicat. Lamp Fr FOG Front fog indicator light OFF or ON -
      Indicat. Lamp Rr FOG*3 Rear fog indicator light OFF or ON -
      Indicat. Precrash*4 PCS warning light OFF or ON -
      Driver Side Door Open Open door indicator light OFF or ON -
      Front Passenger Side Door Open Open door indicator light OFF or ON -
      Indicat. Rear Door RH Open Open door indicator light OFF or ON -
      Indicat. Rear Door LH Open Open door indicator light OFF or ON -
      Indicat. Back Door Open Open door indicator light OFF or ON -
      Indicat. Headlamp Auto Leveling*5 Headlight leveling indicator light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      Indicat. Tire Pressure Warning System*7 Tire pressure warning light OFF or ON -
      Indicat. Lamp ECB Brake warning light / yellow (minor malfunction) OFF or ON -
      Indicat. Lamp ECT PWR Power mode indicator light OFF or ON -
      Indicat. Lamp Cruise Cruise main indicator light or cruise main indicator light (vehicle-to-vehicle distance control mode) OFF or ON -
      Indicat. Lamp Brake Brake warning light / red (malfunction) OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Master Warning Master warning light OFF or ON -
      Indicat. Ready (HV) Ready indicator light OFF or ON -
      Indicat. EV Mode EV mode indicator light OFF or ON -
      Indicat. SET Set indicator light OFF or ON -
      Indicat. Radar Cruise*6 Cruise main indicator light (vehicle-to-vehicle distance control mode) OFF or ON -
      Indicat. ECO MODE ECO mode indicator light OFF or ON -
      HV System Indicator Hybrid system indicator MIN, -50, 0, 100, 200, 300, 400, MAX -
      Meter Display 1 Multi-information display All the dots in the multi-information display OFF or ON -

      • *1: for models with mph unit

      • *2: for models with km/h unit

      • *3: w/ Rear Fog Light

      • *4: w/ Pre-crash Safety System

      • *5: w/ Automatic Headlight Beam Level Control

      • *6: w/ Dynamic Radar Cruise Control System

      • *7: w/ Tire Pressure Warning System