GLOVE BOX LIGHT REMOVAL


  1. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A01J9ZGE01
      Text in Illustration
      *a Lift slightly

      Using a moulding remover, slightly lift the panel at the position shown in the illustration.

    2. Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.

    3. Disconnect each connector and remove the integration control and panel assembly.

  2. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01JA02

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.

    2. A01JAMJ

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.

  3. REMOVE NO. 1 SIDE DEFROSTER NOZZLE


    1. A01JCQ6E01
      Text in Illustration
      *a Lift slightly

      Using a moulding remover, slightly lift the panel at the position shown in the illustration.

    2. Pull the No. 1 side defroster nozzle in the direction indicated by the arrow to disengage the 3 claws and remove the No. 1 side defroster nozzle.

  4. REMOVE NO. 2 INSTRUMENT PANEL REGISTER


    1. A01JBR5

      Pull the No. 2 instrument panel register in the direction indicated by the arrow to disengage the claw and clip.

    2. A01JAS9

      Pull the No. 2 instrument panel register in the direction indicated by the arrow to disengage the 2 claws and remove the No. 2 instrument panel register.

  5. REMOVE GLOVE COMPARTMENT DOOR


    1. Open the glove compartment door assembly.

    2. A01JD7O

      Pull the glove compartment door in the direction indicated by the arrow to disengage the 7 claws.

    3. Pull the glove compartment door in the direction indicated by the arrow to remove the glove compartment door.

  6. REMOVE GLOVE BOX LIGHT ASSEMBLY


    1. A01JBZ4

      Disconnect the connector.

    2. Using a screwdriver, disengage the 2 claws and remove the glove box light assembly.