ELECTRICAL KEY OSCILLATOR (for Rear Side) REMOVAL


  1. REMOVE REAR BUMPER ASSEMBLY


    1. A01JC36E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the rear bumper assembly.

    2. A01JBRJ

      Remove the 2 screws and 2 rear bumper upper stoppers.

    3. A01J94C

      Using a clip remover, remove the 9 clips.

    4. Remove the nut.

    5. A01JA49

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. Disengage the claw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    7. A01J8TB

      Disengage the 5 claws.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. A01J9WF

      Disengage the 4 claws and remove the rear bumper assembly as shown in the illustration.

  2. REMOVE ELECTRICAL KEY OSCILLATOR (ELECTRICAL KEY ANTENNA)


    1. A01JCSS

      Disconnect the connector.

    2. Remove the 2 nuts and electrical key oscillator (electrical key antenna).

      Note

      Be careful when removing the electrical key oscillator (electrical key antenna). If the oscillator is dropped, replace it with a new one.