CAN COMMUNICATION SYSTEM PRECAUTION


  1. PRECAUTION FOR DISCONNECTING BATTERY CABLE

    Note

    When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

    System See Procedure
    Intelligent Parking Assist System

    Click here

  2. PRECAUTIONS FOR STEERING SYSTEM HANDLING


    1. Be careful when replacing parts. Incorrect replacement could affect the performance of the steering system and result in hazardous driving.

  3. PRECAUTIONS FOR SRS AIRBAG SYSTEM HANDLING


    1. This vehicle is equipped with an Supplemental Restraint System (SRS) which includes parts such as airbags for the driver and front passenger. Failure to carry out service operations in the correct sequence could cause unexpected SRS deployment during servicing and may cause a serious accident. Before servicing (including removal or installation of parts, inspection or replacement), be sure to read the precaution for the SRS Click here.

  4. BUS WIRE REPAIR


    1. A01JA7G

      After repairing a bus wire with solder, wrap the repaired part with electrical tape.

      Note


      • The CANL bus wire and CANH bus wire must be installed together at all times.

      • When installing, make sure that these wires are twisted, because CAN bus wires are likely to be influenced by electrical noise if the bus wires are not twisted.

      • The difference in length between the CANL bus wire and CANH bus wire should be 100 mm (3.937 in.) or less.

      • Leave approximately 80 mm (3.150 in.) loose in the twisted wires around the connector.

    2. A01JBG1E15

      Do not use bypass wiring between connectors.

      Note

      The ability of the twisted bus wires to resist interference will be lost if bypass wiring is used.

  5. CONNECTOR HANDLING


    1. A01J8EVE01

      When checking resistance with a tester, insert the tester probes from the backside (harness side) of the connector.

    2. A01JB2QE13

      Use service wires to check the connector if it is impossible to check continuity from the rear of the connector.

  6. PRECAUTIONS FOR INSPECTING OR REPLACING CAN JUNCTION CONNECTOR


    1. If the CAN junction connector is removed from the vehicle for inspection or replacement, make sure to install the CAN junction connector and all wire harnesses to their original locations with tape and the clamps.