PARKING ASSIST ECU REMOVAL


  1. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)


    1. A01J8KR

      Disengage the 3 claws and guide.

    2. Disconnect each connector and remove the No. 2 instrument panel under cover sub-assembly.

  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for LHD)


    1. A01JCZAE01
      Text in Illustration
      *1 Glove Compartment Door Stopper Sub-assembly
      *2 Stopper

      Disengage the claw and release the glove compartment door stopper.

    2. Slightly bend stoppers (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.

    3. A01JBKLE01
      Text in Illustration
      *a Close
      *b Open Approximately

      Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.

      Note

      Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.

  3. REMOVE PARKING ASSIST ECU (for LHD)


    1. A01JBBI

      Remove the nut.

    2. Disengage the claw and remove the parking assist ECU.

  4. REMOVE FRONT DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure described for the LH side Click here.

  5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure described for the LH side Click here.

  6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (for RHD)


    1. A01JA5Y

      Remove the screw <C>.

    2. A01JCRX

      Disengage the 6 claws and clip as shown in the illustration.

    3. A01J9TK

      Disengage the claw and 2 guides and disconnect the hood lock control cable.

    4. Disconnect each connector and clamp, and remove the lower instrument panel finish panel assembly.

  7. REMOVE PARKING ASSIST ECU (for RHD)


    1. A01J9EY

      Remove the nut.

    2. Disengage the claw and remove the parking assist ECU.