POWER MANAGEMENT CONTROL ECU REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01J8KR

      Disengage the 3 claws and guide.

    2. Disconnect each connector and remove the No. 2 instrument panel under cover sub-assembly.

  4. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    1. A01JCZAE01
      Text in Illustration
      *1 Glove Compartment Door Stopper Sub-assembly
      *2 Stopper

      Disengage the claw and release the glove compartment door stopper.

    2. Slightly bend stoppers (A) and (B) in the directions indicated by the arrows in the illustration and pull the glove compartment door assembly until the stoppers are released.

    3. A01JBKLE01
      Text in Illustration
      *a Close
      *b Open Approximately

      Open the glove compartment door assembly to approximately 55° from its closed position. Pull it horizontally in the direction indicated by the arrow to disengage the 2 hinges and remove the glove compartment door assembly.

      Note

      Pulling the glove compartment door assembly upward to remove it causes the hinges to deform. Be sure to pull out the glove compartment door assembly horizontally.

  5. REMOVE ECU INTEGRATION BOX (for LHD)


    1. Disconnect each connector.

    2. A01JB98

      Disengage the 3 clamps and disconnect the wire harness.

    3. Remove the bolt, 2 nuts and ECU integration box.

  6. REMOVE POWER MANAGEMENT CONTROL ECU (for LHD)


    1. A01J8QZ

      Disengage the 2 claws and remove the power management control ECU.

  7. REMOVE ECU INTEGRATION BOX (for RHD)


    1. Disconnect each connector.

    2. A01JAW9

      Disengage the clamp and disconnect the wire harness.

    3. Remove the bolt, nut and ECU integration box.

  8. REMOVE POWER MANAGEMENT CONTROL ECU (for RHD)


    1. A01JCCD

      Disengage the 2 claws and remove the power management control ECU.