INTELLIGENT PARKING ASSIST SYSTEM ECU Power Source Circuit

DESCRIPTION

This circuit is the power source circuit to operate the parking assist ECU. The parking assist ECU controls the intelligent parking assist system.

Tech Tips


  • The parking assist ECU is connected to other ECUs via CAN communication or AVC-LAN communication.

  • If the parking assist ECU does not operate due to a power source problem, a navigation system DTC may be stored due to an AVC-LAN communication interruption.

  • If the parking assist ECU does not operate due to a power source problem, other system DTCs may be stored due to a CAN communication interruption.

WIRING DIAGRAM

A01JB27E14

INSPECTION PROCEDURE

Note

Inspect the fuse for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (PARKING ASSIST ECU - AUXILIARY BATTERY AND BODY GROUND)


    1. Disconnect the L152 connector from the parking assist ECU.

    2. A01JC28E08
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Parking Assist ECU)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L152-4 (GND1) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L152-1 (+B) - L152-4 (GND1) Power switch off 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here