NAVIGATION ECU REMOVAL


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM AUXILIARY BATTERY NEGATIVE TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A01J9ZGE01
      Text in Illustration
      *a Lift slightly

      Using a moulding remover, slightly lift the panel at the position shown in the illustration.

    2. Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.

    3. Disconnect each connector and remove the integration control and panel assembly.

  7. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01JA02

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.

    2. A01JAMJ

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Disengage the 14 claws.

    2. Disconnect the connector and remove the instrument cluster finish panel garnish.

      A01J8FE

  9. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. A01JD4M

      Disengage the 3 claws.

    2. Disconnect the connector and remove the upper instrument panel finish panel sub-assembly.

  10. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET


    1. A01JA1Y

      Remove the 4 bolts.

    2. A01JBHB

      Disengage the 4 claws as shown in the illustration.

    3. Disconnect each connector and remove the radio and display receiver assembly with bracket.

  11. REMOVE NO. 1 RADIO BRACKET


    1. w/o Navigation System:


      1. A01J8WI

        Remove the 3 bolts and No. 1 radio bracket.

    2. w/ Navigation System:


      1. A01JC2K

        Remove the 5 bolts and No. 1 radio bracket.

  12. REMOVE NO. 2 RADIO BRACKET


    1. w/o Navigation System:


      1. A01JBUO

        Remove the 3 bolts and No. 2 radio bracket.

    2. w/ Navigation System:


      1. A01JA1F

        Remove the 5 bolts and No. 2 radio bracket.

  13. REMOVE EXTENSION MODULE


    1. Disconnect each connector to remove the navigation wire and radio cable.

    2. A01J9NR

      Disconnect the connector to remove the extension module.