NAVIGATION RECEIVER REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Click here

    Note


    • After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

    • A hard disk drive (HDD) is built into the navigation receiver assembly to store map data etc. which will be used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the navigation receiver assembly.

  2. EJECT MAP DISC (w/ Navigation System for DVD)


    1. for LHD:


      1. Turn the power switch to ACC.

      2. Push the "INFO" button.

      3. Touch "Map Data" on the navigation screen.

      4. Touch "EJECT DVD" on the navigation screen to eject the map disc.

      5. Turn the power switch off.

    2. for RHD:


      1. Turn the power switch to ACC.

      2. Push the "OPEN" button.

      3. Push the "MAP" button to eject the map disc.

  3. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    1. A01J9ZGE01
      Text in Illustration
      *a Lift slightly

      Using a moulding remover, slightly lift the panel at the position shown in the illustration.

    2. Pull the integration control and panel assembly in the direction indicated by the arrow to disengage the 6 claws.

    3. Disconnect each connector and remove the integration control and panel assembly.

  4. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01JA02

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 2 claws and 2 clips.

    2. A01JAMJ

      Pull the lower center instrument cluster finish panel sub-assembly in the direction indicated by the arrow to disengage the 5 claws and remove the lower center instrument cluster finish panel sub-assembly.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. Disengage the 14 claws.

    2. Disconnect the connector and remove the instrument cluster finish panel garnish.

      A01J8FE

  6. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. A01JD4M

      Disengage the 3 claws.

    2. Disconnect the connector and remove the upper instrument panel finish panel sub-assembly.

  7. REMOVE NAVIGATION RECEIVER WITH BRACKET


    1. A01JCMN

      Remove the 4 bolts.

    2. A01J9QE

      Disengage the 4 claws and remove the navigation receiver assembly with bracket as shown in the illustration.

    3. Disconnect each connector.

  8. REMOVE NO. 2 RADIO BRACKET


    1. A01JA78

      Remove the 4 screws and No. 2 radio bracket.

  9. REMOVE NO. 1 RADIO BRACKET

    Tech Tips

    Use the same procedure for the No. 2 radio bracket.

  10. REMOVE NAVIGATION RECEIVER ASSEMBLY