BRAKE PEDAL (for LHD) REASSEMBLY


  1. INSTALL BRAKE PEDAL PAD

  2. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

    Note


    • Do not drop the brake pedal stroke sensor assembly.

    • If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.

    • When installing a new brake pedal stroke sensor assembly, do not break the brake pedal stroke sensor assembly lever set pin before tightening the 2 nuts.


    1. A01J99ZE02
      Text in Illustration
      *a Brake Pedal Groove
      *b Brake Pedal Stroke Sensor Assembly Lever

      Temporarily install the brake pedal stroke sensor assembly with the 2 nuts.

      Note


      • Engage the brake pedal stroke sensor assembly lever with the brake pedal groove.

      • Check that there is no foreign matter attached to the contact surface of the brake pedal stroke sensor assembly.

      • Check that the tip of the brake pedal stroke sensor assembly lever is protruding from the brake pedal groove.

      Tech Tips

      Fully tighten the 2 nuts after the brake pedal support assembly is installed.