BRAKE PEDAL (for LHD) REMOVAL


  1. REMOVE UPPER INSTRUMENT PANEL ASSEMBLY

    Tech Tips

    Refer to the instructions for Removal of the upper instrument panel assembly Click here.

  2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. A01JB1P

      Remove the 2 screws <D>.

    2. Disengage the claw and guide.

    3. Disconnect each connector and remove the No. 1 instrument panel under cover sub-assembly.

  3. REMOVE STOP LIGHT SWITCH ASSEMBLY


    1. A01JBCH

      Disconnect the connector.

    2. A01JCVG

      Turn the stop light switch assembly counterclockwise and remove it.

  4. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

  5. REMOVE BRAKE PEDAL RETURN SPRING


    1. A01JCI1

      Remove the brake pedal return spring from the brake pedal support sub-assembly and push rod pin.

  6. REMOVE PUSH ROD PIN


    1. A01J9SJ

      Remove the clip and push rod pin to separate the brake pedal sub-assembly from the push rod clevis.

  7. SEPARATE DRIVER SIDE JUNCTION BLOCK ASSEMBLY


    1. A01J9J6

      Remove the bolt and nut, and separate the driver side junction block assembly.

  8. REMOVE BRAKE PEDAL SUPPORT ASSEMBLY


    1. A01JBPF

      Remove the bolt and separate the brake pedal support assembly from the instrument panel reinforcement.

    2. A01J8N6

      Disengage the clamp and disconnect the connector from the brake pedal stroke sensor assembly.

    3. A01JAH7

      Remove the 4 nuts and brake pedal support assembly.

    4. A01J8WE

      Remove the nut from the brake pedal support assembly.