SKID CONTROL BUZZER (for RHD) REMOVAL

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE FRONT DOOR SCUFF PLATE RH

    Tech Tips

    Perform the same procedure as for the LHD Click here.

  7. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LHD Click here.

  8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL

    Tech Tips

    Perform the same procedure as for the LHD Click here.

  9. REMOVE ECU INTEGRATION BOX RH


    1. Disconnect the connectors.

    2. A01JCW5

      Remove the nut, bolt and ECU integration box RH.

  10. REMOVE SKID CONTROL BUZZER ASSEMBLY


    1. A01JC1G

      Remove the skid control buzzer assembly.

    2. Disconnect the skid control buzzer connector.