FRONT SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.


  1. INSTALL FRONT SPEED SENSOR


    1. A01J9RB

      Install the front speed sensor with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 76 in.*lbf }

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Firmly insert the front speed sensor body into the knuckle before tightening the bolt.

      • After installing the front speed sensor to the knuckle, make sure that there is no clearance between the front speed sensor stay and knuckle. Also make sure that no foreign matter is stuck between the parts.

      • Before installing the clamp, firmly insert the points of the clamp into the installation holes.

    2. Temporarily install the front brake flexible hose.

      A01JBGNE01
      Text in Illustration
      *1 Front Brake Flexible Hose *2 No. 1 Sensor Clamp

    3. Install the front brake flexible hose and No. 1 sensor clamp together to the shock absorber with the bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing the speed sensor.

      • Bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front speed sensor is positioned over the front brake flexible hose.

    4. A01J8P9

      Install the clamp to the shock absorber assembly.

    5. A01JAHTE01
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Install the No. 2 sensor clamp to the body with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 76 in.*lbf }
    6. A01JASP

      Connect the speed sensor connector.

    7. Connect the 2 speed sensor wire harness clamps to the body.

  2. INSTALL FRONT FENDER LINER


    1. A01JCFC

      Install the front fender liner with the 12 clips, 3 grommets and 4 screws.

  3. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. CHECK FOR SPEED SENSOR SIGNAL

    Click here