FRONT SPEED SENSOR REMOVAL

Note

While the battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door courtesy switch turns on. Therefore, when servicing the brake system components, do not operate the brake pedal or open/close the doors while the battery is connected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace it together with the front axle hub and bearing assembly.


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE FRONT WHEEL

  7. REMOVE FRONT FENDER LINER


    1. A01JCFC

      Remove the 12 clips, 4 screws, 3 grommets, and front fender liner.

      Tech Tips

      Use the same procedure for the RH side and LH side.

  8. REMOVE FRONT SPEED SENSOR


    1. A01JASP

      Remove the 2 clamps and disconnect the front speed sensor connector.

    2. A01JAHTE01
      Text in Illustration
      *1 No. 2 Sensor Clamp

      Remove the bolt and No. 2 sensor clamp from the body.

    3. A01JCXHE01
      Text in Illustration
      *1 No. 1 Sensor Clamp
      *2 Front Brake Flexible Hose

      Remove the bolt, No. 1 sensor clamp and front brake flexible hose together from the shock absorber assembly.

    4. Remove the clamp from the shock absorber.

    5. A01J9RB

      Remove the bolt and front speed sensor.

      Note


      • Prevent foreign matter from attaching to the front speed sensor tip.

      • Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.