TCM INSTALLATION


  1. INSTALL TRANSMISSION CONTROL ECU ASSEMBLY


    1. A01JBDGE01
      Text in Illustration
      *1 Claw
      *2 Transmission Control ECU Assembly
      *3 LHD
      *4 RHD

      Engage the 2 claws to install the transmission control ECU assembly to the ECU integration box.

  2. INSTALL ECU INTEGRATION BOX (for LHD)


    1. A01JB98

      Install the ECU integration box with the 2 nuts and bolt.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

    2. Engage the 3 clamps to connect the wire harness.

    3. Connect each connector.

  3. INSTALL ECU INTEGRATION BOX (for RHD)


    1. A01JAW9

      Install the ECU integration box with the nut and bolt.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

    2. Engage the clamp to connect the wire harness.

    3. Connect each connector.

  4. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    1. A01JAP5E01
      Text in Illustration
      *a Opened Approximately 55°
      *b Closed

      With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.

      Note

      Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.

    2. A01JD6GE01
      Text in Illustration
      *1 Glove Compartment Door Stopper Sub-assembly
      *2 Stopper

      Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.

    3. Engage the claw and connect the glove compartment door stopper sub-assembly.

  5. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Connect the connector.

    2. Engage the guide and 3 claws to install the No. 2 instrument panel under cover sub-assembly.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  7. INSTALL REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Engage the 2 guides to install the rear No. 3 floor board.

  8. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  9. INSTALL REAR NO. 2 FLOOR BOARD


    1. A01JCWRE01

      Engage the 3 guides <A>.

    2. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.