MILLIMETER WAVE RADAR SENSOR REMOVAL


  1. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01JBUM

      Remove the 3 clips.

    2. Disengage the 2 claws and remove the radiator support opening cover.

  2. REMOVE FRONT BUMPER ASSEMBLY


    1. A01JA91E01
      Text in Illustration
      *1 Protective Tape

      Put protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. A01JD2A

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A01JCMZ

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. A01J8PO

      Remove the 2 bolts and 4 screws.

    5. Using a clip remover, remove the 7 clips.

    6. w/ Front Spoiler:


      1. A01JB7K

        Using a clip remover, remove the 2 clips.

      2. Remove the 2 screws.

      3. Disengage the 2 guides and remove the front spoiler cover.

    7. A01JAQA

      Disengage the 3 claws and remove the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    8. A01JB2B

      Pull back the side of the front bumper assembly as shown in the illustration and disconnect the connector.

      Note

      Do not apply excessive force when separating the front bumper.

    9. w/ Headlight Cleaner System:


      1. A01JD60

        Disconnect the headlight cleaner hose and drain the washer fluid.

        Tech Tips

        Use a container to collect the washer fluid.

    10. A01JA9S

      Remove the front bumper assembly as shown in the illustration.

  3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. A01JAQS

      Disconnect the connector.

    2. Remove the 5 bolts and millimeter wave radar sensor assembly.