CRUISE CONTROL MAIN SWITCH INSTALLATION


  1. INSTALL CRUISE CONTROL MAIN SWITCH


    1. A01JB9C

      Install the cruise control main switch with the 2 screws.

    2. A01J9XU

      Connect the connector.

  2. INSTALL STEERING PAD


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01J8UL

      Connect the airbag connector to the steering pad.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    4. Push in the lock to install the airbag connector.

    5. Connect the horn connector to the steering pad.

    6. A01JCDD

      Push the steering pad to engage the 2 pins.

      Note

      Make sure that the pins are securely inserted into the steering holes.

  3. INSTALL LOWER NO. 3 STEERING WHEEL COVER


    1. A01J99P

      Engage the claw to install the lower No. 3 steering wheel cover.

  4. INSTALL LOWER NO. 2 STEERING WHEEL COVER


    1. A01J949

      Engage the claw to install the lower No. 2 steering wheel cover.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Engage the 2 guides to install the rear No. 3 floor board.

  7. INSTALL REAR DECK FLOOR BOX


    1. Install the rear deck floor box.

  8. INSTALL REAR NO. 2 FLOOR BOARD


    1. A01JCWRE01

      Engage the 3 guides <A>.

    2. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.

  9. INSPECT STEERING PAD


    1. A01JCV3

      Visually check for defects with the steering pad installed on the vehicle.


      1. The defects are as follows:


        • Cuts on the surface and in the grooves of the steering pad

        • Small cracks on the surface and in the grooves of the steering pad

        • Significant discoloration on the surface and in the grooves of the steering pad

        OK
        No defects are found.

        Tech Tips

        If any of the defects is found, replace the steering pad with a new one.

    2. Make sure that the horn sounds.

      Tech Tips

      If the horn does not sound, inspect the horn system Click here.

  10. INSPECT SRS WARNING LIGHT


    1. Inspect SRS warning light Click here.