CRUISE CONTROL SYSTEM Cruise Main Indicator Light Circuit

DESCRIPTION

• The power management control ECU detects a cruise control switch signal and sends it to the combination meter assembly through CAN. Then the cruise main indicator light comes on.

• The cruise main indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER

   
   

   1. Connect the intelligent tester to the DLC3.

   2. Turn the power switch on (IG).

   3. Turn the intelligent tester on.

   4. Enter the following menus: Body / Combination Meter / Active Test.

   5. Check the cruise main indicator light by performing the Active Test.

      Combination Meter

      Tester Display	Test Part	Control Range	Diagnostic Note
      Indicat. Lamp Cruise	Cruise main indicator light	ON / OFF	-

      OK
      The display changes as shown above according to Active Test operation.

   
   

   NG

   REPLACE NO.3 METER CIRCUIT PLATE Click here

   OK

2. READ VALUE USING INTELLIGENT TESTER

   
   

   1. Connect the intelligent tester to the DLC3.

   2. Turn the power switch on (IG).

   3. Turn the intelligent tester on.

   4. Enter the following menus: Powertrain / Cruise Control / Data List.

   5. Check the Data List for proper functioning of the cruise main indicator light.

      Cruise Control

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      CCS Indicator M-CPU	Cruise main indicator (M-CPU)/ON or OFF	ON: Cruise main indicator light on OFF: Cruise main indicator light off	-

      OK
      The display changes as shown above according to cruise control main switch operation.

   
   

   NG

   REPLACE POWER MANAGEMENT CONTROL ECU Click here

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here