TEMPERATURE SWITCH REMOVAL


  1. REMOVE FRONT SPOILER COVER (w/ Front Spoiler)

  2. REMOVE ENGINE UNDER COVER

  3. DRAIN ENGINE COOLANT (for Engine)

    Note

    Do not remove the reservoir tank cap, cylinder block drain cock plugs and radiator drain cock plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. Loosen the radiator drain cock plug and drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the local regulations.

    2. Loosen the cylinder block drain cock plug.

      Tech Tips

      The plug is on the back of the generator on the exhaust manifold side.

      A01JB2ZE01
      Text in Illustration
      *1 Reservoir Tank Cap *2 Cylinder Block Drain Cock Plug
      *3 Radiator Drain Cock Plug *4 Air Release Valve

  4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01JC6S

      Disconnect the engine coolant temperature sensor connector.

    2. A01JADL

      Using a union nut wrench (19 mm), remove the engine coolant temperature sensor.

      Note

      Do not apply any excessive force to the heater pipe when removing the engine coolant temperature sensor.