PCV VALVE INSTALLATION


  1. INSTALL VENTILATION VALVE SUB-ASSEMBLY


    1. A01JAW5E07
      Text in Illustration
      *1 Adhesive 1324

      Apply adhesive to 2 or 3 threads of the ventilation valve sub-assembly.

      Adhesive
      Toyota genuine adhesive 1324, three bond 1324 or equivalent
    2. A01JD1NE01
      Text in Illustration
      *1 Ball Joint Lock Nut Wrench (22 mm)

      Using a ball joint lock nut wrench (22 mm), install the ventilation valve sub-assembly.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a ball joint lock nut wrench is combined with a torque wrench Click here.

    3. A01J91E

      Install the ventilation hose to the ventilation valve sub-assembly.

  2. INSTALL NO. 1 ENGINE UNDER COVER

  3. INSTALL AIR CLEANER CASE


    1. A01JCW8

      Install the air cleaner case with the 3 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Install the hose to the 3 hose clamps.

    3. Install the air cleaner filter element.

  4. INSTALL INLET AIR CLEANER ASSEMBLY


    1. A01JBG6

      Install the inlet air cleaner assembly with the 3 bolts.

      Torque:
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }

    2. Connect the wire harness clamp to the inlet air cleaner assembly.

    3. Install the hose to the hose clamp.

  5. INSTALL AIR CLEANER CAP SUB-ASSEMBLY


    1. A01J8QWE01

      Install the air cleaner cap sub-assembly with the 2 clamps.

    2. Tighten the hose clamp.

    3. A01JAMH

      Connect the mass air flow meter connector.

  6. INSTALL NO. 2 CYLINDER HEAD COVER


    1. A01JAJ9

      Engage the 3 clips to install the cover.

      Note


      • Be sure to engage the clips securely.

      • Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.