FUEL INJECTOR INSPECTION


  1. INSPECT FUEL INJECTOR ASSEMBLY


    1. A01J9MB

      Check the resistance.


      1. Using an ohmmeter, measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 11.6 to 12.4 Ω

        If the result is not as specified, replace the injector assembly.

    2. Check the operation.

      Inspect the injector injection volume.

      CAUTION:

      Perform the inspection in a well-ventilated area.

      Do not perform the inspection near a naked flame.


      1. A01JAGHE04
        Text in Illustration
        *1 SST (Hose)
        *2 Fuel Pipe (Vehicle Side)
        *3 SST (Clip)
        *4 SST (Fuel Tube Connector)

        Connect SST (fuel tube connector) to SST (hose), then connect them to the fuel pipe (vehicle side).

        SST
        09268-31012   ( 09268-41500, 90467-13001, 95336-08070 )

        Note

        Ensure that the SST connector O-rings are not damaged and are free of foreign objects as they are used to seal the connections between the fuel tube connector and pipe.

      2. A01JAIKE08
        Text in Illustration
        *1 SST (Hose)
        *2 SST (Clip)
        *3 SST (Adapter)
        *4 O-ring
        *5 SST (Clamp)
        *6 Vinyl Tube

        Install a new O-ring onto the fuel injector assembly.

      3. Connect SST (adapter and hose) to the injector assembly, and hold the injector assembly and union with SST (clamp).

        SST
        09268-31012   ( 09268-41110, 09268-41300, 90467-13001, 95336-08070 )

      4. Set the injector assembly in a graduated cylinder.

        CAUTION:

        Install a suitable vinyl tube onto the injector assembly to prevent gasoline from spraying.

      5. Operate the fuel pump Click here.

      6. A01J8EKE15

        Connect SST (wire) to the injector assembly and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

        SST
        09842-30080
        Standard Injection Volume
        Tester Connection Condition Specified Condition
        Positive terminal - Ground terminal Per 15 seconds 60 to 73 cc (3.7 to 4.5 cu.in.)
        Difference between each injector
        13 cc (0.8 cu.in.) or less

        Note

        Always do the switching on the battery side.

        If the injection volume is not as specified, replace the injector assembly.

    3. A01JB9E

      Inspect for leaks.


      1. In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leaks from the injector.

        Standard fuel drop
        1 drop or less every 12 minutes

        If there are excessive leaks, replace the injector assembly.