FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note

      Keep the lip free from foreign matter.

    2. A01JANZE01

      Using SST and a hammer, tap in the oil seal until its surface is flush with the front oil seal retainer edge.

      SST
      09223-22010

      Note


      • Wipe off extra grease from the crankshaft.

      • Do not tap the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the pulley.

    2. A01JATRE02
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, hold the pulley in place and tighten the bolt.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
      Torque:
      190 N*m  { 1937 kgf*cm, 140 ft.*lbf }

  3. INSTALL REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH


    1. A01JB4PE01

      Install the rear side rail reinforcement sub-assembly RH with the 4 bolts.

      Torque:
      Bolt A, D
      96 N*m  { 979 kgf*cm, 71 ft.*lbf }
      Bolt B, C
      99 N*m  { 1010 kgf*cm, 73 ft.*lbf }

      Note

      Temporarily tighten bolts A and B, and then fully tighten the 4 bolts in the order of C, B, D and A.

  4. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }

  5. INSPECT FOR OIL LEAK

  6. INSTALL REAR ENGINE UNDER COVER RH