FRONT CRANKSHAFT OIL SEAL REMOVAL


  1. REMOVE FRONT WHEEL RH

  2. REMOVE REAR ENGINE UNDER COVER RH

  3. REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

    Tech Tips

    Perform the same procedure as for the LH side.

  4. REMOVE CRANKSHAFT PULLEY


    1. A01JCAWE02
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, hold the pulley in place and loosen the pulley bolt.

      SST
      09213-58014   ( 91551-80840 )
      09330-00021
    2. A01JAKLE02
      Text in Illustration
      *a Hold
      *b Turn

      Using SST, remove the crankshaft pulley and pulley bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      If necessary, remove the pulley and pulley bolt using SST.

  5. REMOVE TIMING CHAIN COVER OIL SEAL


    1. Using a knife, cut off the lip of the oil seal.

    2. A01JC0NE03
      Text in Illustration
      *a Cut Position

      Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

      Note

      After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.