BATTERY BLOWER INSTALLATION


  1. INSTALL BATTERY COOLING BLOWER ASSEMBLY

    Note


    • Be sure not to touch the fan part of the battery cooling blower assemblies.

    • Do not lift the battery cooling blower assemblies using the wire harness.


    1. A01JBO7

      Install the battery cooling blower assembly with the 2 bolts and nut.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

    2. Connect each battery cooling blower assembly connector and clamp.

    3. A01JB2I

      Connect the 3 wire harness clamps.

  2. INSTALL NO. 1 HYBRID BATTERY INTAKE DUCT

    Note

    Ensure that the duct is installed securely.


    1. A01J9LJ

      Install the No. 1 hybrid battery intake duct with the 2 clips.

  3. INSTALL REAR SIDE SEAT BACK ASSEMBLY RH


    1. A01J9RZ

      Engage the 2 guides as shown in the illustration.

    2. A01JCTM

      Install the rear side seatback assembly RH with the bolt.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  4. INSTALL REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side Click here.

  5. INSTALL NO. 1 HYBRID BATTERY EXHAUST DUCT


    1. A01J8X8

      Insert the No. 1 hybrid battery exhaust duct with the clip.

      Note

      Ensure that the duct is installed securely.

  6. INSTALL REAR FLOOR BOARD SPACER


    1. A01JA4L

      Install the rear floor board spacer with the 2 clips.

  7. INSTALL REAR NO. 1 FLOOR BOARD


    1. A01JBVX

      Engage the 2 claws and 2 clips.

    2. Install the rear No. 1 floor board with the bolt.

  8. INSTALL REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY


    1. A01JCFP

      Engage the claw and 2 clips to install the rear No. 2 floor board sub-assembly.

  9. INSTALL REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY


    1. A01J8Q1

      Engage the 2 claws and 2 clips to install the rear No. 1 floor board sub-assembly.

  10. INSTALL REAR SEAT CUSHION ASSEMBLY


    1. A01JCUFE01
      Text in Illustration
      *1 100 mm (3.94 in.) or less
      *2 Guide
      *3 Hook

      Engage the 2 guides of the seat cushion to the seatback.

    2. Engage the 2 front hooks of the seat cushion to the vehicle body.

      Note

      When installing the seat cushion, make sure that the seat belt buckle is not under the seat cushion.

      Tech Tips

      Confirm that the seat cushion is firmly installed.