BATTERY BLOWER REMOVAL


  1. REMOVE REAR SEAT CUSHION ASSEMBLY


    1. A01JC67E01
      Text in Illustration
      *1 100 mm (3.94 in.) or less
      *2 Hook
      *3 Guide

      Disengage the 2 front hooks of the seat cushion from the vehicle body as shown in the illustration.

      Note

      Follow the instructions below carefully as the cushion frame deforms easily.


      1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

      2. Repeat the above procedure for the other hook.

    2. Disengage the 2 guides of the seat cushion from the seatback.

    3. Remove the rear seat cushion assembly.

  2. REMOVE REAR NO. 1 FLOOR BOARD SUB-ASSEMBLY


    1. A01J8Q1

      Disengage the 2 claws and 2 clips, and remove the rear No. 1 floor board sub-assembly.

  3. REMOVE REAR NO. 2 FLOOR BOARD SUB-ASSEMBLY


    1. A01JCFP

      Disengage the claw and 2 clips, and remove the rear No. 2 floor board sub-assembly.

  4. REMOVE REAR NO. 1 FLOOR BOARD


    1. A01JBVX

      Remove the bolt.

    2. Disengage the 2 claws and 2 clips, and remove the rear No. 1 floor board.

  5. REMOVE REAR FLOOR BOARD SPACER


    1. A01JA4L

      Remove the 2 clips and rear floor board spacer.

  6. REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT


    1. A01J8X8

      Remove the clip and No. 1 hybrid battery exhaust duct.

  7. REMOVE REAR DOOR SCUFF PLATE RH

    Tech Tips

    Use the same procedure described for the LH side Click here.

  8. REMOVE REAR SIDE SEAT BACK ASSEMBLY RH


    1. A01JCTM

      Remove the bolt.

    2. A01JB67

      Disengage the 2 guides and remove the rear side seatback assembly RH as shown in the illustration.

  9. REMOVE NO. 1 HYBRID BATTERY INTAKE DUCT


    1. A01J9LJ

      Remove the 2 clips and No. 1 hybrid battery intake duct.

  10. REMOVE BATTERY COOLING BLOWER ASSEMBLY

    Note


    • Be sure not to touch the fan part of the battery cooling blower assemblies.

    • Do not lift the battery cooling blower assemblies using the wire harness.


    1. A01JB2I

      Disconnect the 3 wire harness clamps.

    2. A01JBO7

      Disconnect the battery cooling blower assembly connector and clamp.

    3. Remove the 2 bolts, nut and battery cooling blower assembly.