HEATED OXYGEN SENSOR INSTALLATION


  1. INSTALL HEATED OXYGEN SENSOR


    1. A01JCO0E01
      Text in Illustration
      *1

      Fulcrum Length

      300 mm
      *2

      Fulcrum Length

      30 mm

      Using SST, install the heated oxygen sensor onto the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note


      • This torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.81 in.) and SST with a length of 30 mm (1.18 in.) Click here.

      • This torque value is effective when SST is parallel to the torque wrench.

    2. A01J8EE

      Connect the wire harness to install the wire harness clamp bracket.

    3. A01JA6S

      Install the wire harness clamp bracket with the bolt.

      Torque:
      12 N*m  { 127 kgf*cm, 9 ft.*lbf }

    4. Install the wire harness bracket.

    5. Connect the heated oxygen sensor connector.

  2. INSPECT FOR EXHAUST GAS LEAK

  3. INSTALL NO. 2 ENGINE UNDER COVER


    1. A01JBN1

      Install the No. 2 engine under cover with the 4 clips.