AIR FUEL RATIO SENSOR INSTALLATION

INSTALL AIR FUEL RATIO SENSOR
1. Using SST, install the air fuel ratio sensor.
  
  SST
  
  09224-00010
  
  Torque:
  
  without SST
  
  44 N*m { 449 kgf*cm, 32 ft.*lbf }
  
  with SST
  
  40 N*m { 408 kgf*cm, 30 ft.*lbf }
  Note
  
  The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
  
  The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) Click here.
  
  This torque value is effective when SST is parallel to the torque wrench.
2. Connect the air fuel ratio sensor connector and clamp.
INSTALL NO. 2 CYLINDER HEAD COVER
1. Engage the 3 clips to install the cover.
  Note
  
  Be sure to engage the clips securely.
  
  Do not apply excessive force or hit the cover to engage the clips. This may cause the cover to break.
INSPECT FOR EXHAUST GAS LEAK
INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
1. Install the outer cowl top panel sub-assembly with the 9 bolts.
  
  Torque:
  
  12 N*m { 122 kgf*cm, 9 ft.*lbf }
2. Bend the water guard plate RH and engage the claw.
3. Bend the No. 1 heater air duct splash shield seal and engage the claw.
4. Engage the clamp to install the wire harness.
INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
1. Install the outer cowl top panel with the 9 bolts.
  
  Torque:
  
  12 N*m { 122 kgf*cm, 9 ft.*lbf }
2. Bend the water guard plate RH and engage the claw.
3. Bend the No. 1 heater air duct splash shield seal and engage the claw.
4. Engage the clamp*2 of the wire harness.
5. Engage the clamp*1 and connect the connector (w/ Windshield Deicer).
6. Engage the clamp of the wire harness.
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
1. Install the windshield wiper motor and link Click here.