AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. Remove the windshield wiper motor and link Click here.

  2. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    1. A01JCF9

      Disengage the clamp and separate the wire harness.

    2. A01J9NS

      Disengage the claw and bend the No. 1 heater air duct splash shield seal.

    3. A01JC64

      Disengage the claw and bend the water guard plate RH.

    4. A01J9P5

      Remove the 9 bolts and outer cowl top panel sub-assembly.

  3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    1. A01JAH2

      Disengage the clamp and separate the wire harness from the outer cowl top panel sub-assembly.

    2. A01JB4QE01

      Disengage the clamp*1 and disconnect the connector (w/ Windshield Deicer).

    3. Disengage the clamp*2 and separate the wire harness from the outer cowl top panel sub-assembly.

    4. A01J9F7

      Disengage the claw and bend the No. 1 heater air duct splash shield seal.

    5. A01JBZC

      Disengage the claw and bend the water guard plate RH.

    6. A01J9HT

      Remove the 9 bolts and outer cowl top panel sub-assembly.

  4. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01JAJ9

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  5. REMOVE AIR FUEL RATIO SENSOR


    1. A01JCNW

      Disconnect the air fuel ratio sensor connector and clamp.

    2. A01JBJ8E01

      Using SST, remove the air fuel ratio sensor.

      SST
      09224-00010