CAMSHAFT POSITION SENSOR REMOVAL

Tech Tips

Although the part name refers to the No. 1 crank position sensors, this procedure is for the camshaft position sensors.


  1. REMOVE NO. 2 CYLINDER HEAD COVER


    1. A01JAJ9

      Remove the 3 clips and No. 2 cylinder head cover.

      Note


      • Attempting to disengage both front and rear clips at the same time may cause the cover to break.

      • Pull the cover straight up to remove. Attempting to pull the cover forward may cause it to break.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the cover to break.

  2. REMOVE NO. 1 CRANK POSITION SENSOR


    1. A01JCORE01

      Disconnect the No. 1 crank position sensor connector.

    2. Remove the bolt and No. 1 crank position sensor.