ECM REMOVAL


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the power switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the power switch off, make sure to wait at least 60 seconds before disconnecting the cable from the negative (-) battery terminal.

  2. REMOVE REAR NO. 2 FLOOR BOARD


    1. A01JB5ZE01

      Disengage the 2 guides <A> as shown in the illustration.

    2. Disengage the 3 guides <B> and remove the rear No. 2 floor board.

  3. REMOVE REAR DECK FLOOR BOX


    1. Remove the rear deck floor box.

  4. REMOVE REAR NO. 3 FLOOR BOARD


    1. A01JC33

      Disengage the 2 guides and remove the rear No. 3 floor board.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. SEPARATE RADIATOR WITHOUT CAP RESERVE TANK ASSEMBLY


    1. A01J8MD

      Remove the 2 bolts and separate the radiator without cap reserve tank assembly.

  7. REMOVE ECM


    1. Remove the No. 1 relay block cover.

    2. A01JAY2

      Disconnect the 3 wire harness connectors.

    3. A01JBSR

      Disengage the 2 claws, push up the engine room wire harness and separate it from the engine room relay block.

    4. A01JAGL

      Disengage the 2 claws and push up the side cover to remove it.

    5. A01JCP5

      Loosen the bolt and separate the No. 2 engine room wire.

    6. Disconnect the 2 ECM connectors.


      1. A01JC3Y

        Disconnect the 2 wire harness clamps.

      2. Push the locks on the 2 levers, then raise the levers, and disconnect the 2 ECM connectors.

        Note

        After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

    7. A01J9T8

      Separate the 2 wire harness clamps.

    8. A01JAMF

      Remove the 2 bolts and ECM with 2 ECM brackets.