NAVIGATION SYSTEM (for Navigation Receiver Type) Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier

DESCRIPTION

This circuit sends a signal to the stereo component amplifier assembly to mute noise. Due to this, the noise produced by changing the sound source ceases.

If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.

If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.

WIRING DIAGRAM

A01JAZCE29

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. A01J91XE10
      Text in Illustration
      *a

      Component with harness connected

      (Stereo Component Amplifier Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L143-1 (MUTE) - Body ground

      Power switch on (ACC), audio system playing

      → Changing modes

      Above 3.5 V

      → Below 1 V

    NG

    CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY) Click here

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

  2. CHECK HARNESS AND CONNECTOR (NAVIGATION ECU SUB-ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the navigation ECU sub-assembly connector.

    2. Disconnect the stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L130-20 (MUT2) - L143-1 (MUTE) Always Below 1 Ω
      L130-20 (MUT2) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT STEREO COMPONENT AMPLIFIER ASSEMBLY (OUTPUT SIGNAL)


    1. Reconnect the stereo component amplifier assembly.

    2. A01JBUWE09
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Navigation ECU Sub-assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      L130-20 (MUT2) - Body ground Power switch on (ACC), audio system is playing Above 3.5 V

    NG

    REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY Click here

    OK

    REPLACE NAVIGATION ECU SUB-ASSEMBLY Click here