NOISE FILTER REMOVAL


  1. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    1. A01JC1S

      Using a moulding remover, disengage the clip and claw.

    2. A01JD3V

      Using a moulding remover, disengage the clip and claw.

    3. A01JA9PE01

      Disengage the 3 clips in the order shown in the illustration.

    4. A01J91Z

      Disengage the 2 clips by pulling the back door trim board assembly in the direction indicated by the arrows in the illustration.

    5. A01JC5YE01
      Text in Illustration
      *1 Back Door Trim Board Assembly
      *2 Back Door Panel
      *a The portion that may be damaged due to interference

      Remove the back door trim board assembly by pulling it in the direction indicated by the arrow in the illustration to disengage the 4 clips.

      Note

      Make sure to pull the back door trim board assembly in the direction indicated by the arrow in the illustration. If the back door trim board assembly is removed from the lower part, the door pull handle mounting area may interfere with the back door panel, resulting in damage to the back door trim board assembly.

  2. REMOVE NOISE FILTER

    Note

    When the terminal cover is removed, the noise filter must be replaced because the terminal cover and condenser are supplied as a set.


    1. A01J8PI

      Remove the bolt.

    2. Disengage the clamp and disconnect the noise filter with the wire harness from the vehicle body.

    3. A01JBLBE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver wrapped with protective tape, disengage the 3 claws and remove the terminal cover with the wire harness from the condenser.

    4. Using a screwdriver, bend back and break off the claw as shown in the illustration.

      A01JC5D

    5. Remove the terminal cover from the wire harness.